636 cutting out, not pulling hard on idle
Registered User
Joined: Mar 2008
Posts: 157
From: Okc, OK
i think its the to much maintenance heart attack scenario. im gonna have to pull a bubash and just get a whole other bike
Registered User
Joined: May 2008
Posts: 941
From: Tell City, Indiana, US
Re: 636 cutting out, not pulling hard on idle
JB YOUR PROBLEM IS YOU DONT LIVE CLOSER TO ME SO YOU DONT HAVE VIP ACCESS TO MY SPARE PARTS FOR DIAGNOSTIC REASONS!!!
AND BUBASH YOU CAN'T HELP HIM YOU ARE TO FAR AWAY TO.
GRAHAM
AND BUBASH YOU CAN'T HELP HIM YOU ARE TO FAR AWAY TO.
GRAHAM
Registered User
Joined: Oct 2006
Posts: 1,323
From: Pittsburgh PA 15209
Re: 636 cutting out, not pulling hard on idle
i have nothing to offer you except a shoulder to cry on, if i had to guess id say check throttle bodies for any obvious obstruction or tps sensor goin bad. try other throttle bodies
Registered User
Joined: Oct 2006
Posts: 1,323
From: Pittsburgh PA 15209
Re: 636 cutting out, not pulling hard on idle
Thread Starter
Registered User
Joined: Jan 2007
Posts: 2,027
From: blackwell ok.
Registered User
Joined: May 2008
Posts: 941
From: Tell City, Indiana, US
Registered User
Joined: Aug 2008
Posts: 70
From: nj
Re: 636 cutting out, not pulling hard on idle
check the valve timming it could have jumped when you removed the tensioner. you should always have the engine at tdc when servicing the tensioner or timming chain.
Thread
Thread Starter
Forum
Replies
Last Post
