Ok here is the situation. A few weeks ago I was doing fine just learning how to roll my endos...about 15ft to 20 on a good one. Lately when I've been trying them I've been locking them up ALOT. I have come up with a few theories as to why this is happening.

Bubble in the break lines.
My pads are low...need to be changed but not terrible.
Tire needs to be changed....doesnt seem to bad though.

Anyone have any clues? I'm not doing anything different I don't think. I've found that pulling hard with my pinky and ring finger seems to work better for some reason.

 

My front brakes are about shot and my tire is starting to bald off, and I have no problem rolling stoppies. I don't think that is the problem.

 

my tire will lock up when the pavement is smooth...check out the surface that you are doing it on that may be the reason

 

It Is colder and your tires aren't as sticky (just a guess) try letting a lil air out of the front that seems to work for me just remember it is low when out doing other **** !

 

Think I may have figured it out...would have deffinatly figured it out if my buddy Rich hadn't balled a christ tonight.

 

blow me, bitch.

 

yo rich what happened???

 

Hey dude, it was classic at least now it gives you an excuse to get a new engine cover.

 

I got up into a tank christ at way too low of a speed, ate ****, bike tried to run me over, blew the case open, oil everywhere, and had to trailer it home. Im out of commission until I get a new engine cover at the end of this week. Fun stuff.

 

Yo, Monday when I get back we ride!