old post diging

 

Just leave it, It wont effect the bike scraping, circling or drifting(well maaybe diiirty drifting) and will kill it if it flips or lands on its side

 

Wow i cannot believe people had issues with this, just walked outside clipped the green and the red, used a butt connector and combined them on the side leading towards the headlights not into the black box, didnt touch the white wire, fired it up and leaned my bike on the side. 3 minutes. simple.

 

i just did that and thought it was a ground issue....glad i found this thread

 

good one...haHAHAH

 

So I have a 1999 cbr600f4i I was wandering when they started the tip over sensor there is no dash or plastics on my bike and wasn't when I got it so I was wandering if it was supposed to have one and if that was the cause of my no spark issue if it is supposed to have the tip over sensor what color are the wires I have to cut and contact? I read that it's the green and red and white and you leave the white hanging but wanted to double check that the colors are the same please help and thanks in advanced I hoping this works I'm dieing to finally have this bike running.