i have a quick question....I read this entire thread, reply by reply but no where in here does it say WHERE the friggin wires are....lol, i know its a stupid question, but WHERE on/in the bike are these red, green and white wires located? (i can't tell from the pics either)

also, i read many different methods of doing it....is there one thats better than the other?

 

theres a black box hidden behind ur gauge cluster, the wires run to that...

and its wires dude, do what ever works.

 

i assume that you mean behind the speedo and the tacho? ....do i have to take off the front plastic or is there an easier way? (i've taken off sides but never the front)

 

you should just leave it alone, untill ur doing idle wheelies u have no worry, and by the time u have idle wheelies your upper (front) will be demolished.

 

i've got a 905 cage

but just to confirm....if i'm doing 11s at say 20-30mphs an hour, i shouldn't worry? i don't understand what speed has to do with the sensor kicking in, can you explain?

 

its a pendelum switch, when the bike ends up on its side it will shut off, when ur doing circles and 2am scrapes, thats when u need to worry about it. after u drop your bike a few times u will eventualy demolish your front fairing and speedo tacho stay. and then u will bypass it

 

oh i see. thx.

 

Well I Completely Fucked This Up... I Cut The Wire On The Wrong Side So Now Both Wires Are Too Short To Splice Together... What The **** Do I Do Now...

 

well i got it all figured out and hooked up.... just takes some patience...

 

lol, for a second there you though you were totally fucked huh? ..i hate that feeling

 

yeah i was.... just sitting inmy garage staring at all the ****** wires...lmao... smoked a couple bowls and figured it out tho...:YEAH

 

havnt done the mod yet....if it doesn't rain tomorrow which i know it will, im gonna take off all the pastics & do this mod.

 

Also just as a side note.
"funny things to do with your leftover tip over switch"
Wire it into a freinds car ignition system mounted sideways so every time he goes to take off the car just stops dead.Then just starts again with out it would seem for any reason
When this is done try very hard not to fall over laughing in your driveway as he leaves....

 

is there any way i can remove tip sensor and have it spliced green n red wires ? I gut no room for tip sensor anywhere cuz i have banana seat or where it suppose to be located ?

 

read these three pages over and over till u put 2 and 2 together to make 4

 

I said , is there any way i can remove tip sensor and have the wire spliced....and i know theres two more wires to spliced as well.

 

splice what? u just gotta gorund the red and white wire running to the tip sensor.

 

never mind , i got it mang.

 

dude you got to be kidding me, read these three pages and you will know how to remove the tip switch succcesssssfully

 

where did you get this jumper? i went to autozone, nappa and radio shack and none of them have it.