My mortgage is a mess. I planned on re-financing a year ago when the 3 year fixed rate was up, but now I am so upside down I am just paying the intrest. (intrest only loan). Basically I am using my house like an apartment, but I can claim the payments I make on my taxes.
Mortgage:$639.84 including taxes and insurance
HELOC:$148.97
Rent payment to me:$420

 

I am ******* broke this week. Looks like I will be riding the bike a lot to work next week. If I can go until thursday without filling up the truck, that's $50-60 I can save, but I don't know if I even have enough fuel to make it to work tomorrow and back and forth to the wedding site 2 times. My friend is getting the shaft on the wedding gift. His fault for getting married the day before Fathers day and having a cheap *** for a best man.

 

I'm all about finances the morning of payday.

 

My airbox and velocity stacks are getting dropped off at my house today. maybe I can get some work done on the 954 during my week off. If I get the subframe grinded down, the undertail back on, and all of the wiring/gauges/battery done i will be happy.

 

Yesterday afternoon i replaced the broken front wheel studs on the neon. SOOOOO much easier than the rears.
I noticed the front pads are shot, and one of the rotors is fucked from it already. Actually, it looks like the rotor was already fucked, and it tore through one of the pads in a hurry. So this weeks pharm sales profits will buy some new pads and rotors. I sure hope theyre not expensive, theyre little rotors so they shouldnt be too much.
I think when i build my dream garage, it will have a lift.

 

do you have to grind the sub for the undertail to fit or something? Whats up with that?

 

Rotors for that will be cheap. I'm guessing $80 for the pair at vato zone.

 

Someone welded 2 large pieces of aluminum square stock to the subframe. It did add a lot of strength, but it wouldn't work with an aftermarket undertail.

 

after this, the neon should pass inspection finally

 

ahhhh

what clown would do that? lol

 

has been the lassst 3 days

 

What's inspection?
Not Scotty otherwise he would have bragged about it as a selling point.

 

I'm replacing rocker panel pieces on mine to get it to pass inspection. Right side is done, left side will be done tonight. I'm cutting out the rust and welding in 16 ga. sheet metal.

 

$24-$45 each depending on what quality you want.

 

+1 on both points

 

Maybe I will try to get the YZ to start using 1/2 a can of ether.

 

you guys dont have annual inspections yet? or you dont care?

 

i dont think they check body work on our inspections here, just safety ****, and emissions

 

tow it with a truck until it starts

 

Only like 18 states have vehicle inspections.