Re: zx6r running like shit Did he tell you how this happened? He had this clam parked on the bar and it fell over on the left side. Probably knocked some shit loose in the bowls. I'm guessing that there is shit stuck in the low speed/pilot jet. It was running fine before that point. Jeff we'll dig into it tomorrow. I have everything you need here at the shop to drill it out if needed. |
Re: zx6r running like shit ha ha asshole i already cleaned everything |
Re: zx6r running like shit Yeah, like you cleaned the outside of the bowl off......:LOL |
Re: zx6r running like shit well yeah:LOL, ill show you in a few hours:cheers |
Re: zx6r running like shit fuel injection.....woop woop! |
Re: zx6r running like shit He's too broke to have a real bike. :broke Maybe next year..... |
Re: zx6r running like shit Still running like shit, did the pilot jets, found some crap in the main jet of the #1 carb, ran fine for a few till it warmed up and it had a habit of flooding..... Wonder if he screwed up the float level when it fell ff the 12 bar. |
Re: zx6r running like shit ill rip into it tomorrow and see what i find:yeah |
Re: zx6r running like shit Check the float level and if you want to come down early next week, I'll rig up a mercury switch and relay for your fuel pump. |
Re: zx6r running like shit ill let you know :banghead |
Re: zx6r running like shit ok on the intake side the is a small air jet that spitting fuel????? :banghead can figure it out |
Re: zx6r running like shit you have to be more specific, pics? |
Re: zx6r running like shit ha ha, hoping you'ld get on. Hang on a sec |
Re: zx6r running like shit the one circled in red [IMG]http://i368.photobucket.com/albums/oo130/vegasrider2005/carb6666.jpg[/IMG] |
Re: zx6r running like shit take the bowl off remove the float make sure the neddle is properly set(hooked around the float arm, it's a tiny wire loop) reassamble. i knock mine off/out of place shakin it, and it would squirt gas out the top. |
Re: zx6r running like shit checked that ten time its all good:banghead i think i need to get insurence then burn it to the ground |
Re: zx6r running like shit maybe you will see something i dont:shruggs [IMG]http://i368.photobucket.com/albums/oo130/vegasrider2005/carb66667.jpg[/IMG] |
Re: zx6r running like shit that main jet looks mangled up to me. it should be fine since its 4 stroke but i know on my two stroke a jet was messed up like that once and reall fd it up and wouldnt run smooth at all. my 2cts on that last picture from just looking. good luck |
Re: zx6r running like shit i did that after the fact but went threw and cleaned everything for the 4th time and set the float hights seems to be running right but i cant let it run for to long cuz its almost 11 at night:banghead |
Re: zx6r running like shit Ok, did you set the float level like I did with the #1 cylinder at the shop? I think when you dropped the thing, you might have bent the metal tab that controls the float level. If the tab is bent, no matter how well the needle sets. It's of no use if it's not being allowed to fully close due to improper adjustment. |
All times are GMT -4. The time now is 08:25 PM. |
© 2024 MH Sub I, LLC dba Internet Brands