929 popping out of gear? help
929 popping out of gear? help
So my buddy has a 929 and everytime he is in 2nd gear and lays into it, it pops out of gear. And it only happens in 2nd gear and when he gives it alot of throttle!Im thinkin one of the shift forks could be bent and its not pushing the gear all the way over and it slips out! im not to sure. does anyone have and suggestions? thanks.
Re: 929 popping out of gear? help
ya i know how to do it, just hate breaking the cases apart...But would it be worth it to change the forks or do u think the tranns is for sure messed up?
Re: 929 popping out of gear? help
word .. this is a no brainer .. replace it have it done in a hour .. and they take the "bad" one apart and see what the problem is .. if its the forks.. find em from somewhere else and replace em.. then u got another good spare tranny
Re: 929 popping out of gear? help
Sounds like you are going to have to pull the motor and split the cases. Yea there is possibly a bent shift fork or 3... But I bet the dogs on the gears have been rounded too.
Re: 929 popping out of gear? help
So i took out the drum and shift forks and on the left fork that puts it into 2nd gear, the fork was worn down to where there was no lips on the end of the fork. So im jus gonna put new forks in it and hopefully she works!
Re: 929 popping out of gear? help
i would check the dogs on the gear that that shift fork is attached to... i just did a trans in an r6 and i replaced the gear also cuz with it slipping out like that it usually rounds off the dogs... and the dogs are the round nubs sticking off the gear that engane it into the other gear next to it
Thread
Thread Starter
Forum
Replies
Last Post
yuppivore
Stunting Help and Advice
3
Jan 26, 2014 11:53 PM







sucks... 

