need help! 03 gixxer 1k
need help! 03 gixxer 1k
ok im new to the streetbikes but allways wanted one and a few months ago picked up a 2003 gsxr 1000 for a good deal, story on the bike was someone pissed someone off and the bike fell victom to being kicked over, gas poured on it and lit it on fire. only real damage was melted wiring so the owner at the time micky moused the wiring with tape and road it for about six months that way till i bought it off him. i bought a new main harness and a new lock/ignition set put everything on and now the bike wont run. its been sitting for roughly 6 months total now and would like some help if possible.
i ran the codes in dealer mode and this is what i got
c13
c14
c15
c21
c23
c29
c41
c42
c46
Re: need help! 03 gixxer 1k
Found these online, C13 wasnt listed but I can get ya that one when I get home and look it up in the manual.
Here ya go:
C14 - THROTTLE POSITION SENSOR
C15 - ENGINE COOLANT TEMPERATURE SENSOR
C21 - INTAKE AIR TEMPERATURE SENSOR
C22 - ATMOSPHERIC PRESSURE SENSOR
C23 - TIPOVER SENSOR
C24 - IGNITION SIGNAL #1
C25 - IGNITION SIGNAL #2
C26 - IGNITION SIGNAL #3
C27 - IGNITION SIGNAL #4
C28 - SECONDARY THROTTLE VALVE ACTUATOR
C29 - SECONDARY THROTTLE POSITION SENSOR
C30 - SECONDARY THROTTLE CONTROL UNIT
C31 - GEAR POSITION SENSOR
C32 - INJECTOR SIGNAL #1
C33 - INJECTOR SIGNAL #2
C34 - INJECTOR SIGNAL #3
C35 - INJECTOR SIGNAL #4
C41 - FUEL PUMP CONTROL SYSTEM
C42 - IGNITION SWITCH SIGNAL
C46 - EXHAUST CONTROL VALVE ACTUATOR
Here ya go:
C14 - THROTTLE POSITION SENSOR
C15 - ENGINE COOLANT TEMPERATURE SENSOR
C21 - INTAKE AIR TEMPERATURE SENSOR
C22 - ATMOSPHERIC PRESSURE SENSOR
C23 - TIPOVER SENSOR
C24 - IGNITION SIGNAL #1
C25 - IGNITION SIGNAL #2
C26 - IGNITION SIGNAL #3
C27 - IGNITION SIGNAL #4
C28 - SECONDARY THROTTLE VALVE ACTUATOR
C29 - SECONDARY THROTTLE POSITION SENSOR
C30 - SECONDARY THROTTLE CONTROL UNIT
C31 - GEAR POSITION SENSOR
C32 - INJECTOR SIGNAL #1
C33 - INJECTOR SIGNAL #2
C34 - INJECTOR SIGNAL #3
C35 - INJECTOR SIGNAL #4
C41 - FUEL PUMP CONTROL SYSTEM
C42 - IGNITION SWITCH SIGNAL
C46 - EXHAUST CONTROL VALVE ACTUATOR
Last edited by K-Dubz; Dec 5, 2008 at 07:08 PM.
Re: need help! 03 gixxer 1k
ive looked over the wiring and cant find anything wrong, its pretty straight forward green plug to green plug, red plug to red plug im not sure if theres some kinda relay or switch that might be bad thats why i posted cause maybe someone here has had this same problem
Re: need help! 03 gixxer 1k
C13 is the Intake Air Pressure Sensor
If you are gonna fix all this urself I would highly suggest buying the factory service manual from a dealer cause it'll have all the specs you need to fix this stuff
If you are gonna fix all this urself I would highly suggest buying the factory service manual from a dealer cause it'll have all the specs you need to fix this stuff
Thread
Thread Starter
Forum
Replies
Last Post






