I have a K6 that i am doing a rebuild on. I have everything off the neck but it will not drop out of the frame. I tapped it with a rubber mallet and still nothing. The bike set outside for a few mopnths when i had no garage could there be any corosion holding it in? (there was corosion holding in swing arm pivot) ANY HELP?????????

 

when in doubt, hammer it out!!! go check www.bikebandit.com to make sure you have everything removed!

just double, then tripple check everything before you wack the **** out of it.
*is the bearing seized up on the steering stem? never seen it, just asking!