i think the clutch is burnt up but i cant tell for sure.

i swapped out motors and when im riding, i cant get power to the wheel after 8-9000 rpms. it just revs out as if im pulling in the clutch. then if i go to clutch it up, its just revs out without any sort of pull. even if im in 6th gear cruising, i cant get it to go over 100 without down shifting to 3rd or 4th.

i adjusted the line and it seems ok. when i had the motor in the other frame, i couldnt really get it to come up, i had to bounce VERY hard in second to get it up. even first was hard to get up.

i have brand new plates and springs in the blown motor, but i dont want to swap them out until i get some suggestions.

thanks in advance

 

first, adj. clutch cable as loose as possible on the top & bottom of line, then pull off rubber plug on left side case,youll see a stud & nut, loosen nut & loosen stud all the way( it wont come out). now adj. cable back where its suppose to be, now screw in the stud til its tight,then back off half turn,lock it in place with the nut. do a slight adj. on cable again & go do some 3rd gear wheelys