Looking for some advice on what idle to run with gearing for circles..


I've only had 2 days of practice on my friends f4i with +8 -2 gearing.. I ran 3500 on that, and thats what I learned to cut TWO staggard circles on..

I think the idle was too high though, because I was constnatly raping the brake during the circle..


Now were getting ready to re-gear his bike... Going +20 -2.... I know I know, its a parking lot bike, so were going HUGE for fun..

So what rpm should I run for +20 -2 for learning circles?





Also, I'm getting ready to go +14 on my f4i, what rpm should I run on it?




Just looking for the best advice so I don't waste time learning with a harder to ride setup..

 

i have NO idea.

i say just start low(1k rpm), and make ur way up.

 

yep find out what you like and go with it

 

i have a 60T f4i - i idle at 2500-2700rpm (i still have gauges)

 

not to open new thread...if someone can tell me how much throttle should I apply on 900rr (measure in cm please) once I dip it in...?

 

nice

 

haha. yeah man its all preference. id say keep it low and gas'er! it looks better in my opinion. or if you run a high idle... keep em tight and fast.

 

On stock gears I ride about 2000 rpm .. mabe a little more some times less. depends on what im feelin.