Im just about finished doing a few things with my bike.. but i cant seem to wire up my Acerbis Diamond Headlight. for my 636

I've used to search but cant seem to find what im looking for.

If anyone has any diagrams or help .. greatly appreciated!

 

anyone

 

do you still have your left hand controls ?
if so just use the factory wires for the stock head light if not run some wires directly to the batt with an inline fuse and a toggle switch

 

i do still have the factory headlight wireing.. thats what im hooking it up too . just dont know which one goes where n ****

 

on a 636 the head light only gets power once you have hit the start button so turn on your key hit your start button then turn the bike off with the kill switch not the key and then just use a test light [or your acerbis] to figure out which wires have power...

p.s make sure you check with the high low beam switch in both positions so you know which is high and which is low

 

Get a toggle switch and run a wire from the battery then run a ground wire to the frame. Thats what I did and I can still put the stock upper on and not have to **** around with redoing wires.

 

^^^ this kids a ******* idiot.