i heard u need 2 cut ur exhaust shorter so it doesnt break off/scrape on a 12, and i was just wondering if thats true where on the pipe do u cut it. i have a muzzy exhaust along the side of the swingarm not undertail

 

cut it in half

 

Just cut it. You'll like it.

 

it's not hard

 

Put your stocker back on then cut the end off. But when ya do- cut the outside first put the end plate back on and the cut the inner tube. use what you can to hold the end plate on (screws, rivets, welder, or luck) It'll be good as used but shorter. Oh and put the fiberglass back in so we wont hear you from 2 miles away!!

 

if it has rivets you just cut it 6-8" from the end and then drill the rivets out, put the cap on the new end, and drill and rivet it back on.

if you have your stock pipe I would cut that

 

no i dont have the stock pipe, but the actual muffler itself should be cut or the connecting pipe from the header 2 the slip on. cause i heard the bike wont perform the same it did when it was whole