If you start making your trans shift harder , remember that power transfers thru the driveline . You better have fairly new u-joints

 

same **** different toilet

 

I tried using those extractor bolts but it didnt work. Is that sorta the same thing? And what about something like this

http://www.speedwaymotors.com/p/2919...mover-Kit.html

 

OMR SUBCAGE (S)
OMR SUBCAGES available:
Honda

• CBR F4i - 01, 02, 03 <<< click here, will also fit the single seat style with minor mods
• CBR 954- all years
• CBR 929- all years
• CBR 600RR - 03 , 04 , 05 , 06 , 07 <<< click here

Kawasaki

• zx6r/rr (636) - 03, 04, 05, 06 07 08<<< click here

Suzuki

• GSXR 600/750 -00, 01, 02, 03, 04, 05
• GSXR 1000 -01, 02, 03, 04

Yamaha

• R6 - 03, 04, 05 <<< click here
• R6s (old body style) - 06, 07, 08

$175 Shipped
pay pal accepted

Tech

• The 03-06 CBR 600RR , 03-05 Yamaha R6 ,03 04 gsxr 1000 and the f4i pegs are lowered and moved back and out for better peg position! !
• The 01-03 GSXR 600 and 750 have the pegs moved out two inches because of the big tail section
• THE 07 600RR pegs are located 2-1/2 inches lower and 3 inches wider (Than stock)
• All other omr subframe cage models are in the stock location except they are rotated on their axis so they don't fold up unless you fold them up, this also puts your foot on the grippy part of the peg during a wheelie.
• omr subcages are available for all makes and models but only the ones listed above are available for shipping

click here to contact >> old man roger

the original folding peg subcage!!!!!!!!

>>click here to see why i only sell folding peg subcages<<

 

A REALLY easy way to see if your plug wires are arching , wait till night time , open the hood and rev it up . You'll see the wires arching (if they are)

Wires will arch more under a load . I would say have Jackman ride under the hood while you drive down the street , but he might not go for that .

 

the tool in your link works ok if there is alot of the bolt sticking out

 

smokie time

 

yeah it was...

 

Time to go back out to da streets/lot...

 

yeah it pretty much snapped off and left alot sticking out on both studs. I tried using 2 nuts - 1 as a locknut and 1 to extract and I was able to get both nuts on but that didnt work either You think they sell those stud remover kits at home depot?

 

no thanks, i already had to check if he had spark once, "hold this and see if it's workin..."

"****!!! yea, you got spark"

 

ah, he's half mexican... they ride in the trunk

 

Have fun.

 

eh i think im giving up and gonna just deal with the **** the way it is FUCKKKKKKKKKKK

 

how bad is it??

 

alright, goin out ridin again for little bit

 

quiter

 

word

 

im out too , going riding .....

 

later man