Calling aLL NY stunters and stunteresses
Re: Calling aLL NY stunters and stunteresses
It does it pretty sporadically. It's like completely random. It won't do it all the time. It's bugging me out. If it was bent it would probably do it constantly.
It will do it it every once in a while, but then sometimes do it over and over for like 5 minutes straight. It's ******* weird. Re: Calling aLL NY stunters and stunteresses
. Re: Calling aLL NY stunters and stunteresses
Anyone got any ideas on what this could be... my F4i's been doing this for a little while now. If I'm cruising around on idle without touching the throttle at all on 2 wheels, my F4i will like buck. It will slow itself down as if there's mad engine brake, then lunge forward. I hear the chain or something click when it does that too.
Re: Calling aLL NY stunters and stunteresses
buddy of mine just sent me list of f4i parts... anyone got any of this stuff?
front and rear tire
under tail and brake light
bitch peg
right side rear set and peg
battery
upper fairing
upper stay
front brake master
wind screen
pass seat
chain
stator cover
cluster
front and rear tire
under tail and brake light
bitch peg
right side rear set and peg
battery
upper fairing
upper stay
front brake master
wind screen
pass seat
chain
stator cover
cluster
Re: Calling aLL NY stunters and stunteresses
ok,,,, get the bremvo in bleed the brakes all over again... feels spongee but w.e gto get usto it... so i go by my house to try it out on some wheelies ... do a couple ok its catching.. feels weird on idle cuz it was nothing like my old gsxr master more stopping power less finger power... so do a wheelie and put it down go to turn around and hit the hb boom nothing... look at my rear caliper leaking bf but didnt see from where... ffrom the looks of it my pads dont let go of the rotor the were mad hot like o.d so wtf is the problem... im getting my 4 piston single bracket withing the week but what can cause the pads from not letting go?
Re: Calling aLL NY stunters and stunteresses
ok,,,, get the bremvo in bleed the brakes all over again... feels spongee but w.e gto get usto it... so i go by my house to try it out on some wheelies ... do a couple ok its catching.. feels weird on idle cuz it was nothing like my old gsxr master more stopping power less finger power... so do a wheelie and put it down go to turn around and hit the hb boom nothing... look at my rear caliper leaking bf but didnt see from where... ffrom the looks of it my pads dont let go of the rotor the were mad hot like o.d so wtf is the problem... im getting my 4 piston single bracket withing the week but what can cause the pads from not letting go?
For the leak check the crush washers. If you reused the same crush washers they could be leaking from there. Happened on my bike and Ricky's bike. Other than that Gil the Natural can offer advice I'm sure. Oh if it is the crush washers Drew showed me a way to reuse them that works. Take a torch to them and heat them up for 20 or 30 seconds (off the bike obviously) and they'll expand again so then you could reuse them. Or you could go to autozone and just buy new ones but in a pinch you could heat and reuse them. Autozone sells packs with all different sizes but they also sell single crush washers that they usually have stored in the back somewhere. At least the autozone next to Nicks shop had single ones like that. Brap. Re: Calling aLL NY stunters and stunteresses
I got a front brake master I'd sell. How much?? I could bring it this weekend.
Re: Calling aLL NY stunters and stunteresses
I have rear passenger pegs and brackets, and i have a chain and sprocket setup for sale..








