from the sounds of it you might have it way before then

 

i like the sound of that.

does patterson have lights?

 

looks like im riding tonite too...he jus called me to pick it up

 

not the street spot. and usually if i tag along to east side high we get run outa there during the week

 

word... go get that **** and meet up later to get it in

 

could be but the installer was eric. we put on new throttle cables the other day and the atown cage gets in the way so its hard to get the screwdriver through the hole in the frame to tighten one of the screws. whatever tho - its on now.

 

Any1 know where I can get C channel steel from? I'm going to have a new 12 built. I twisted mine last night.. whew-hew.....

 

loop?

 

Yup... YUT-UGH

 

Oh.. any! looking to sell a front end or a fork at least.. My **** now looks like a boomerang. hahaha

 

Not all Home Depots may carry it but try a few different ones. I found mine at the Yonkers location off Jackson Ave.
Oh and no luck with those forks so I would just post up a wanted ad on here and check ebay.

 

Sam was putting in work yesterday.

 

I found a spot with the C channel. I know we said 1/4" but what length and height should I get?

 

i made my own 12 bar outa flat stock. the guys checked it out monday night. the sides are 1" wide and 3/8th thick. maybe give that a shot

 

Can you post any pics of it?

 

Word.
Done and Done

 

yeah i'll go snap some right now. give me a few mins

 

this pic shows where i ground the flat bar to bend it and then i ran a weld in the bend to strengthen it up after.

 

its not perfect but it does the job really well

 

yoo .... your bike yellow ?