Hey all i just got a pair of race railz off of ebay for my 2003 zx6r. The below pic is the hardware it came with (long rear bolt not pictured). I was wondering if these bolts are the right size?? they look a little long to me but i have not done this before either...
and where does that bushing go (the silver piece?)
what about the rubber pads? where do they go?

 

who made the rails

 

rubber go under under rail on mounting point

 

if it doesnt tighten up go to the hardware store and get the different lengths. How are we supposed to know? If your bolts the size of a lighter will work on your bike, with unsaid brand of race railz....I rock steel innovations brand race rails for stunting and they work just fine.

 

That looks right. I wanna say the long bolt is for the right side. The pads go behind the rails where it butts up to the frame toward the rear.
I hope your a gangster or good at making saves because the stator cover will still hit.
I had those on my last 03'
Those are powers btw

 

shoulda went with steel innovatons then. I wrecked about 5 times today and everyting is great! Ive been down hard several times too!

 

and the spacer goes on the left side

 

the spacer goes in front or on back on the left? I mean i would prob figure it out when i go to do it...just waiting on some new fairings to get here until i take it apart


what is this steel innovations company...i dont see them on google



thanks for the replies guys!

 

man i wish i had not gotten these then

I am not planning on doing major stunting but if i drop it i want something on my bike that will prevent any body damage...getting rid of my sick innovations cage for an '03 636 btw....or maybe i will just paint it black and put it on my bike.... haha i cant make up my mind what i want!!@!#$#@!$#

 

the lighter goes under the rubber piece

 

^^

 

Why would you ditch an SI cage to run Powers race rails?

 

yeah, leave the SI and sell the railz...

 

SI will offer you the most protection while learning....

 

no keep the railz and sell me the cage

 

front

 

the reason i would be getting rid of my SI cage is i just got new fairings and dont really want to cut a hole in them! I was looking at the speed freak motorsports cage and that looks like the best bet. Dont have to cut a hole in the fairings and i think it looks better than an SI...


does the bushing go in between the rail and the frame or what? still confused on that piece

 

between the rail and the frame on the front left motor mount bolt.

how much for the fairings? Dont throw out some stupid price like your charging more for a used cage than a new one.

 

dont be a girl. Run the SI

 

i will take a clean cut hole in the fairings any day over a crack in the case