aight,ive got the 05-06 forks swingarm wheels swap on my 04 636 (like johnnyP)and my idle sucks.cant sit down no handers for **** now.i also cut down my stock exhuast.i just saw starboyz yesterday in windber and the one dude on a 04 636 idle looked so strong and pulled effortlessly.I know that the 05 swingarm and wheel swap could throw off the geometry of the bike but wouldnt it just put the balance point and a different angle?think its the cut down exhuast or any ideas?

 

putting a 05 swingarm and wheel on a 03-04 636 severly kills the idle. There are sensors in the 03-04 wheels that help control the idle, did you swap them over to the 05 wheels? Thats prolly your problem.

 

sensors in the wheel? i dont know bout all that,you might want to check the blinker fluid as well

 

if you chopped the exhaust, did you **** up the muffler bearings?

 

its the fetzer valve

 

kaneuter valve?

 

what?

 

no no no, its the swungarms reverse 3rd pivot hinge! i've seen this happen to a few bikes b4

 

check your flux capacitor

 

The recipercating connuter valve always gave me problems

 

bru...tle

 

? Why Did You Go And **** Up A Perfectly Good Machine

 

+1

 

ditto

 

there are no sensors on the rear wheel stupid....
there on the inside of the 03-04 fork tubes, duh.
and make sure your helmet colors match your bike color other wise the idle circuit goes into limp mode and wont let you idle it up

 

Check the power steering pump.

 

is the swing arm leaking fluid

 

it could also be the air ride sensor ... mine was completly gunked up , little bit of brake parts clean and it was golden

 

when was the last time you checked the dydraulic fluid
in the gauge cluster? or the rear seat air pressure???
all crucial factors

 

you might need a new powerband when doing the conversion.

does anybody know how to stop the bucking on a f4i?