ha any pun intended on the word tweek?

We bend the bracket a little bit but you can hear a scraping noise. None of the bolts are scraping. Im guessing its the cable. Anyone have a picture of how they bent the bracket?

 

haha, no, no pun intended. if you look at where the actual cable comes out on the bottom you'll probly notice that the cable is rubbing on the threaded part where you adjust it(down below), just bend the bracket till the cable stop rubbing.

 

cool. Ill go check it out. Ill snap a picture of it so you all can get a look.

 

snap it fool snap it

 

sweet.............

i'm gonna try this on my 900rr. i when i put a msr pro raptor on my 636 it was great no more hurting or tired fingers/hands, i just got a 900rr and put one one there and it helped, but i need more. even with a msr pro raptor on it and its still just as hard if not harder to pull than my 636 was stock.
and yes, its on the right setting (bottom closest to the bars).

i'm gonna try this this weekend, luckily i found this thread b/c i was about to try that moose clucht pully system garbage.

extending it a 1/2" should be good?????

 

before you do the mod, check to see if the cable is rubbing on the threaded part at the bottom adjustment. i put a moose lever on my 900 and it didn't seem to make much of a difference, until i found out my cable was rubbing and that was the whole problem.

 

you can also just lengthen your clutch lever by welding an extension onto the end if you dont wanna do this mod and it works the same. Ive seen MSR's and Moose's that are an inch longer than when they are brand new and it is like warm butter.

 

Haha, between the extended clutch lever and the bent HB lever, that setup looks like ***

 

Any way to do this with the motor still in the frame? I guess you'd just pull the cover...?

 

Stuntriding aint a fashion show young one, but if you'd like I can send you a parasol and you can sashey your pretty little self all around the lot?

 

that would be my best trick too

 

So, what happen if i pull out the cover?? Do i have to be aware of something or what??

 

You should be able to do it without draining oil but you should be cautious other than that no youll be ok

 

word up 50im with ya there
and nice thinkin KJ

 

I did this mod while ago, I didn't take motor out from the frame. Easy. Righteous stunt clutch and this mod, rocks

 

Thrope is making a clutch arm mod, just wait for his. it going to be

 

Im sitting here wanting to do this but on my 636 it has that curve on the clutch arm how did u guys work around this

 

when you bolt it crank it down it will straighten

 

about what size bolts would I need to use on the clutch arm to clear the case?

 

excellent idea... must try that one, especially with stronger springs...