f4i could have shorter wheelbase...

if it'd make everybody feel better i can take pics of the chain and box w/ spare links

i just put a new 520 RK 120xso on a new geared steel 60 a couple days ago....

 

the distance between the front sprocket and rear sprocket must be different even if the wheel base was the same

 

makes sense....

 

Yeah, t depends too on where you like running your rear wheel. If you like it closer to the engine side of the swingarm you're gonna lose a few links compared to running it further towards the back of the swingarm.

 

Hmmm, I might have been too late on that one.

 

not on an f4i...

i just put this chain on 4 days ago... i like the adjuster as close as possible... but for some reason i couldn't get it there.... so i had to turn em way out.

There IS NOT a FEW links between full out and fully adjusted in... maybe a half a link or one if that.

 

yep same on the 636 the chain would have to be loose as hell and adjusted all the way back for me to be able to take out one link and still have it work

 

what about a -1/+20 on a 06 600rr with a 130 link

 

a 130 will cover that just fine but a 120 will not.

 

i know if you talk to the people at thrust they know how many links you need and i suspect hai and warped toys would also know ...

but my guess is a 130 should cover it..

 

Where does everyone order their 130 link chains from?

 

i get my gears and chain from thrust..

 

k cause I just got my stuff and I ordered a 15/63 with a 130.... had to send back my hb cause me like a dumbass ordered brake instead of the clutch side...

 

what kind of master did you order..

 

shindy

 

ok cause the front master will work you just have to mount it upside down and run a longer hose to the res as long as it has a remote res not one that is attatched to the master

it's funny because some on else just asked the same question...lol

https://www.stuntlife.com/forums/2-s...-how-****.html

 

yeah I just read it... but I tried to mount it but it was very uncomfortable so I just sent it back for the clutch....

 

you did get the one that has the little hose that goes to the res not the one that has the res as part of the master right ?

because the one that has the res connected to the master doesn't fit good at all with the clutch...

 

yeah it has a hose and the res.... I fit the res perfectly but couldn't get the ez pull and the hb in a good position cause hb upside down was hard to get everything to fit perfectly so just swapped it out....

 

cool cool