Rediculous refrence.

 

thats my boy jeremiah wreck happened in tampa, fork snapped at like 35, bikes totalled.

 

All I can say is Damn

 

well well , ,its been a week and my shoulder is still seperated and my road rash is healed , bikes still totalled but i wanna ride

 

+1

 

my 954 forks are leaking by the lower seal of the fork leg. Good thing I don't roll endos

 

if they are leaking from around the tube at the bottom they can break just from putting down a wheelie........

i would change them if i were you or at least tighten them but if there leaking it might be to late for just tightening them

 

now thats fucked up.... im madd sketched out by this.

 

Ha Ha he is making the O face like O FU%k....Or O snap lol

 

Ok There Is A Set Screw On The Inside Of The Fork ,on The Bottom Part That Your Axle Goes Through

Take Off Your Wheel And Put The Axle Back In

Loosen The Set Screw And Thread The Fork Tube[the Chrome Part]back Into The Bottom Of The Fork[the Powder Coated Colored Part]

If Your Forks Are Already Leaking There It May Be Too Late For Just Tightening

This Is Only An 03 04 Problem 05 06 636 Forks Are Made By The Same Company That Make Honda Forks So They Do Not Have This Problem I Am Told

 

joe verticals 05 06 636 forks snapped as well . . . . . so if they re the same company as hondas . . . . . beware honda boys !!