Been Gone For A Year... Whats The Latest On Hb Set Ups ? read this thread jb 420

 

i was running a 98 zx-9 5/8 master before this. there is no comparision. like i said 2 is for a peice of mind more ten it is needed...

 

you got the best of everything and a RUBBER line?put a braided line and it'll tighten that lever up.

Rodger: thats sweet,nice easy bracket to make.how thick did you go on the steel?ship it to me and i'll powder coat it red for you

 

im working on the line- laziness lol

 

haha it's not pretty enough to powder coat and i don't remember how thich it is i will look in a minute when i go out for a cigarette,it's pretty thin though it doesn't have to be real thick ...

 

roger, did u notice that big of a difference between the calipers? i want to do this, i think ill try it this week, ill hit u up if i have questions kay?

 

it's 0.125 so thats like 1/8 of an inch thick ,but mine is realy close to the stock location so there isn't alot of leverage trying to bend my braket but on an f4i or some thing that you have to make it longer i would maybe go a little thicker but on a 636 it's perfect like that

 

a world of difference......

but get ready to learn how to be real gentle with your foot brake ..lol

 

sounds good, u dont have alittle better pic of what you did to mount it do u?

 

no just turn up the brightness on your monitor...

 

oh wait does your gsxr have that little bar going to the caliper like the 02 has if so it's gonna be a whole different deal......

 

how did u mount the back bolt to the stock bracket? guess im not catchin on fast today sorry

 

on the rear bracket to bracket i just used a nut and a bolt ,on the bracket to caliper one the caliper is threaded so just a bolt

 

is the back one really close to the rotor?

 

no not realy ...did you check to see if you have thay bar going to your caliper like the 02

 

dean that setup sucks... u wanna be as far out on the hb as possible for the most leverage.. run clutch on the outside, brake inside.. and cut the clutch lever... i will tak some pics of mine and num2's later today.. he has the brembo, i have a gix radial

 

no i dont why? i see, yours is 636 i guess i really wasnt payin enough attention. that it was f4i

 

i am confused the one in the pic i posted is my 636 what are you doing this mod to an f4i or a gsxr ?

 

f4i bro

 

ok then you are going to have to put your caliper back a little further then mine so you can get it low enough because of you try to put it like mine you wont be able to get the pads low enough,and i used 1/8 steel flat stock i suggest you go a little thicker because your braket is gonna be a little longer,and you may need a longer brake line depending on what line you have on it now