I need to know how to jump and start the bike since I dont have left assy grip control ...can anyone point a finger which color wire to jump thanks.

 

red/white to a ground and be in neutral to start it lol

 

There is many different colors on the clips , orange with red strip n all that so i need know which exactly to jump then i ll be able to start up the bike

 

actully i think its white with red stripe but smae thing... i don't think there is a red with a white stripe... well i dunno but its the tip switch that u need to jump and thats the color at the main harness

 

There is no red and white on the left clip that attached to clutch lever n switch control.

 

u need to be in neutral then

 

alright i ll check it up later.

 

i'll figure out the colors for u later for the clutch switch... im at work till 5.. or i may quit and they make me leave lol

 

lol , lemme know whats the color thanks mang

 

I just did this last night....


The 2 wires you need are in the gray 12 wire plastic harness connector (NOT THE ONE THAT HAS THE RED AND GREEN TIP WIRES IN IT!!!)... they're the 2 in the top center... I don't remember the exact colors, I THINK they're green and green w/ a brown stripe.

If you look at the harness, they are the #4 and #5 wire from the side that has the blue and orange wires... the left side.


I'll have to take a look to get you the exact colors, but if you just jump them w/ a small wire it's pretty easy to figure out.

 

Just looked it up... green/white and green/red.

 

thanks for the help , i m gunna do it right now and see how it goes from there.

 

No prob man... lemme know if you need any more help.

 

yo u gut pm