ok one of you fiddy pros tell me whats wrong i put my bor kit on i did it right to the best of my knowlege not geting any directoins with it, and now it leak oil it looks liek it might be coming out of the exhaust or were the head meats the jug i noticed when i let it idle for about 15 min after i threw the kit on

 

these are the common prob,

mix up the green and black o ring
or the knock pins are in the wrong hole

 

yup, common thing is to forget an o ring. very important to have all that in place. if its coming from between the head and jug, thats gotta be the problem.

 

gota be the green i know for a fact i didnt put that in i think

also when it cranks it makes a hissing sound

 

damn boy you coming into a bunch of probs huh

 

ok by the green o ring do u mean the black one d that like has a smaller green one inside it cuz i didnt see a green one

and lets say you are in the front of the bike there should be 2 on the right bottom side one on the back of the jug and one in the front thats how i did it, but now i am thinkin there should be one on each side on the bottom ????

 

the one u are missing goes just under the head. it slips over the bottom left stud if looking at the front of the engine. oil reaches the head by traveling up the same slot the stud goes into. thats y there is a copper washer for that stud only on the top of the cylinder head. easy fix. good luck.