Stooge

Can anyone shed light as to why my main fuse (a 30) keeps blowing? It happened twice, and luckily I carry spares cos once its blown theres no power to the ignition, no power to anything! Its the one located on the same mount as the regulator/rectifier under the seat.

Uncle.

Have you checked the reg?
I dont realy know much about this stuff but Boxer is good with it so he may be of some help to you.

grandmasterb

Yeah i would start with the regulator rectifier, you normally know when there on the blink as a funny eggy smell is pretty distinctive when they burn out.

Have you unplugged it and put the multi across it at all Stooge???

OOO

mines been doing the same. just carry a **** load of spares :P

Boxer

Check all your terminals and connections for corrosion and bad connections. Does the starter motor sound ok when you're cranking it, it's its a bit cactus it might be drawing too many amps.

Uncle.

wot he said

Elmo

um, i'm not sure how it happens, i'm replying to get my post count up..

Uncle.

also wot he said

Stooge

No, everything sounds fine... it just burns them outta the blue! Started about 2 weeks ago. Ill start checking the wiring I think...

grandmasterb

It is a HONDA after all Stooge

Bender

Let me know WTF caused this problem, when I was up in QLD after about an hour straight the bike was cutting out on me and not blowing fuses, I also had the same fuse problem you had but mine was a short off the loom....

Best of luck...

r6 n shit

probly a pinch in the wiring harness happend on my r6

david skelton

i'd start with your solinoid FIRST i had the same problem on my 600RR

Stooge

Thanx for the posts peeps, will look into it all

Boxer

You know how I told you to set your idle at 15,000rpm Stooge

I was just kidding!

MR. RYAN SMITH

You Have An Open Circuit Somewhere In Your Harness. Could Be A Pinched Or Frayed Wire, Could Be A Certain Electrical Part Failure. How Often Does It Occur?

blownhemi

As dave said check ya solinoid 1st use to blow em on my blade.

Stooge

It happens only when stuntin so far. I will look into the bits mentioned, cos when stuntin, its the only time I have the fan override switch on to keep motor cool, so maybe its overloading something and blowing it.

Ben Blade

wire in a circuit breaker ...........
sounds like a wireing fault to me, have u found when it happens?
like when the bike gets hot ie thermo fan!!!

Boxer

Maybe also chech the earth harness that has all the green wires. If that is corroded or loose it could also be causing your prob