Vertical Mischief Crew Photo Gallery
www.verticalmischief.com
Wisconsin

warning examine your footpeg brackets

Thread Tools
 
Old Nov 30, 2003 | 11:47 PM
  #1  
Miltown's Avatar
Thread Starter
Registered User
 
Joined: Dec 2002
Posts: 1,918
From: Milwaukee, WI
Miltown is an unknown quantity at this point
warning examine your footpeg brackets

all i have to say is people please examine your footpeg brackets, if you do any standups, because mine snapped clean off while doing a standup at 40, (back passenger bracket).

bike went down on the left side, crash cage collapsed into the case cover, blew that apart, and cracked the motor casing too....sure is fun sliding behind a bike in a pool of oil, must have been about 2 feet wide and a 75 yards of oil on the road. Bike just kept going and going. Not to mention the two buddies behind me that where up on one wheel and had to set down and swerve to avoid from running me over.

Had to goto ER too to make sure my ankle wasnt broken, now im on crutches with a broken bike in the basement.

Im just glad it wasnt on the freeway, so please check your brackets for hairline cracks, I plan on designing something a lot stronger, so that this will never happen again.

jesse
Old Dec 1, 2003 | 12:23 AM
  #2  
phatboy's Avatar
Registered User
 
Joined: Oct 2002
Posts: 2,391
From: cold a$$-wisconsin
phatboy is an unknown quantity at this point
hey man glad to hear your not to bad and that whole hot oil thing i know all about.so im guessing that motor will go real cheap now huh j/k but thanks for the warning man.you got all winter to fix the bike and heal. but you better crutch your *** down on the 6th lol
Old Dec 1, 2003 | 06:58 AM
  #4  
MartyB's Avatar
Registered User
 
Joined: Dec 2002
Posts: 4,660
From: Janesville,wi
MartyB is an unknown quantity at this point
glad your ok! where did it snap at?? the peg or the bracket itself?
Old Dec 1, 2003 | 01:32 PM
  #5  
binder929rr's Avatar
back in the saddle again
 
Joined: Apr 2003
Posts: 7,322
From: terre haute, IN
binder929rr is an unknown quantity at this point
ya, i'm replacing mine with steel so if anything they just bend. i hate how aluminum snaps.

also, that's common on yamaha's because the brackets are narrow and longer than most other bikes. i've saw 3 videos so far of it happening on yamaha's.

before i ride, i check my clip ons, front and rear axle nuts, tightness of (subframe bolts, front pegs, and rear pegs), chain condition and looseness, and i check for damage to foot pegs.

i'm paranoid about that ****.

glad you are ok
Old Dec 1, 2003 | 03:54 PM
  #6  
Miltown's Avatar
Thread Starter
Registered User
 
Joined: Dec 2002
Posts: 1,918
From: Milwaukee, WI
Miltown is an unknown quantity at this point
ya it was the actual bracket itself, snapped right off, i knew right away what happened even before touching the ground....i had leather pants under my jeans, so just a very soar ankle. very good timing though since i have that 954 motor.
Old Dec 1, 2003 | 07:37 PM
  #7  
shepdawg's Avatar
Registered User
 
Joined: Oct 2002
Posts: 3,942
From: the church of Rev. horvon von horvath
shepdawg is an unknown quantity at this point
glad to hear your ok man
Old Dec 1, 2003 | 07:38 PM
  #8  
Ryan S's Avatar
I Chose to No Longer Post
 
Joined: Oct 2002
Posts: 10,865
From: milton, wi
Ryan S is a decent person
glad your alright jesse......my left driver peg has been broke since june.....it flexes when you put pressure on it...but with all the staggard pos. wheelies i keep my weight on my bitch peg...guess i should probably change that damn thing now.....glad your allright though man!!!!
Old Dec 1, 2003 | 08:45 PM
  #9  
joey b's Avatar
Registered User
 
Joined: Nov 2002
Posts: 4,277
From: fort atkinson wi.
joey b is an unknown quantity at this point
atless it winter time now

glad to hear your ok
Old Dec 1, 2003 | 10:31 PM
  #10  
phatboy's Avatar
Registered User
 
Joined: Oct 2002
Posts: 2,391
From: cold a$$-wisconsin
phatboy is an unknown quantity at this point
weavers knows all about crashing
Old Dec 1, 2003 | 10:32 PM
  #11  
joey b's Avatar
Registered User
 
Joined: Nov 2002
Posts: 4,277
From: fort atkinson wi.
joey b is an unknown quantity at this point
and u dont
Old Dec 1, 2003 | 10:51 PM
  #12  
phatboy's Avatar
Registered User
 
Joined: Oct 2002
Posts: 2,391
From: cold a$$-wisconsin
phatboy is an unknown quantity at this point
joe don't you have something to go break lol
and i think im getting the hang of this whole crashing thing but i still got a long ways to catch up to you and duker lol
Old Dec 3, 2003 | 01:10 AM
  #13  
Ninjadude's Avatar
Registered User
 
Joined: Oct 2002
Posts: 1,952
From: WI
Ninjadude is an unknown quantity at this point
Glad you're alright Jesse. That sux ***. I wonder if that bracket got weakened in that crash that happened b4 you got that bike?
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
speedjunkies
Bike Parts for Sale
0
Jan 14, 2013 05:55 PM
Kyle XXX
Events & Stunt Competitions
171
Mar 4, 2007 12:23 AM
brownclan
Comedy Central
3
Feb 6, 2003 04:08 PM
DCMETRO1
Stunt Discussion
6
Dec 5, 2002 01:10 PM




All times are GMT -4. The time now is 02:31 PM.