ailemo

was wondering if anyone has figured out the mystery behind where and how to fix this problem and if they have,could you share it with me?

420gixxer

open it up and fill it with caulk,close it back up

o.d.c.

on an 03 model it is mounted right in front of the battery (between the battery and the tank). just pull it off, unclip the wire, take the four screws loose and remove the metal cap, put some zip ties on each side of the ring that floats inside. put it back together. i have heard that certain types of caulks and silicones can be conductive and make the bike not run at all so i used zip ties. hope this helps

420gixxer

i just used the cheap white silicone,i have had no troubles

ailemo

thanks fellas much appreciated ill tell you how it works!

cesarstuntz

how about on a 2001 gsxr 1000?

o.d.c.

on an 01 it is exactly like i described above. (thats what i ride)

GSE_Anthony

Hey guys I have a friend that wants to know if on the gsxr1000 there is a way to completely remove the switch box by clipping the wires and just connect the ones you need?
Like the way some people do on the 929.

Thanks.

Spencer75south

if i havent done anything to mine on my F4i... if im just doing a stand up on the highway its not gonna cut out is it? i dont have a 12 bar so its not going back that far.

clutchit

Its located in front of the battery.. all I did was remove it, took it apart and used electical tape to keep the little magnetic half moon device in there from swinging side to side. Put it back together and put it on the bike.

Ninja Jay

on the f4i... it wont cut out from doing regular wheelies... but will when you get into 12's...

the box is in the very front of the plastics in between the head lights.... there are three wires... i dont remember the colors.. but i do know that you need to cut all three of them but tape the two wires on the outside together and just tape off the middle one... and never have a problem again... you do this and the bike doesnt start after that... then you probably blew a fuse... that happened to me...

-bobble

mako

can't do it that way it has to be in the wiring harness. you have to fill it with silicone/caulk

-----on the f4i the outside wire colors to be spliced together are green and red. the middle white wire gets taped over and buried

yellowjacket

let it cut out at 12 then just use the clutch as a handbrake

GSE_Anthony

Thanks man.

..jk..

Do not fill the box with any glue,caulk or any other bullshit. simply use the zip tie method. Zip ties are the easiest and will not affect any other operation of the bike. Filling that box with some gue is just asking for trouble. Later on...jk www.theuprightsstuntteam.com