Question....
#1
Question....
I accidently scraped for my first time today, and I slightly tweaked my subframe (the right side is higher than the left). It's not really noticable unless you stare, but still...
What do you do to bend it back?
What do you do to bend it back?
#2
Re: Question....
just take about a four foot piece of strong stell and put it over the one side of the sub and under on the other and have a big buddy hold/sit on the bike and push the piece of metal towards the groud until its straight
#3
Re: Question....
Originally Posted by NBSTUNTERZdave
just take about a four foot piece of strong stell and put it over the one side of the sub and under on the other and have a big buddy hold/sit on the bike and push the piece of metal towards the groud until its straight
#4
Re: Question....
leave it, if you bend it back and it gets bent again and so on and so on it will get even weaker and might break. Like when you bend a wire back and forth till it breaks.
#5
Re: Question....
yeah, but if you bend it back its good and straight. dont just go out and do it again so you bend it again, this time brace it up so its harder to bend...
#8
Re: Question....
Originally Posted by NBSTUNTERZdave
just take about a four foot piece of strong stell and put it over the one side of the sub and under on the other and have a big buddy hold/sit on the bike and push the piece of metal towards the groud until its straight
Originally Posted by SirStuntsalot
leave it, if you bend it back and it gets bent again and so on and so on it will get even weaker and might break. Like when you bend a wire back and forth till it breaks.
Learning to scrape on a crooked bar is continuous crashing waiting to happen.
Thread
Thread Starter
Forum
Replies
Last Post