Can I do it with the Valve cover off and just watch the Cam Chain
?

 

yes but to be honest if the wheel turns then the motor is turning ...

 

Alriht

 

jus tried, Wont turn....

 

did you try it in first gear or a higher gear ? and did the tire just skid ?

 

1st and ya just skid

 

try it in 4th

 

jus did, same thing

 

ok thats bad , did you run the bike at all with the cct backed all the way out ?

 

That was the Last time I started it.....

 

Didnt Drive it or anything Just started it for a second/

 

you may have jammed a valve through one of your pistons ........

did you turn the bike off or did it just stop running ?

 

turned it off I believe

 

so u did start bike with cct compleatly loose?????

 

well if you had too much slack in the timing chain there is a good chance you did some damage valves , one valve may be hitting a piston ...

if you can roll the bike backwards in a high gear and then let the clutch out to see if the tire rolls backwards then you will be able to tell if thats the case ...

 

1- ya I did

2 Ill give it a try, Shoudl it roll or no

 

if the piston is jammed against a valve it should roll a little because the piston will be going down away from the valve instead of up against the valve but eventually even going backwards it will go back up and hit the valve again and then it should turn going forward for a little bit

 

damn the cc prolly did slip almost has to be that!

 

Fu*, Just tried it, The Wheel turns a Little Bit when I go backwords, then A little Bit as I go back forward. so How Do I fix this!

 

probably be cheaper to buy a used motor than to fix that one if the valve hit the piston