07 zx6r wont start need help
#1
07 zx6r wont start need help
i ride a o7 zx6r. been in a crash a while ago and my ram air cracked.. it was getting ready to crack all the way through soon and it would be just hanging by wires and i didn't want that.. so instead of buying a new ram air i took the front fairing off kinda like a cheap streetfighter now.. before my bike ran and started perfect and after i took it off my bike started but shut off after a couple seconds and now wont start at all.. all plugs that were connected before are still connected so i dont understand what could make it do this... the ignition and ecu fuse arnt blown
#3
#4
Re: 07 zx6r wont start need help
there were 3 plugs.. one for the speedo.. one the was bulted to the ram air that is like 4 inches from the speedo plug and one more about a foot down from the speedo... but it never tipped over the crash was almost a year ago just never got it all my parts fixed...it ran perfectly fine last night when i unhooked it all
#5
Re: 07 zx6r wont start need help
it doesn't run.. it started and ran for about 5 seconds then shut off whether kick stand was down or up or in gear or neutral.. now doesn't start at all
#7
Re: 07 zx6r wont start need help
well since the upper fairing assembly is off that could make sense why it wont start... is there a way to bypass that and what does the tip over sensor look like
#8
Re: 07 zx6r wont start need help
there were 3 plugs.. one for the speedo.. one the was bulted to the ram air that is like 4 inches from the speedo plug and one more about a foot down from the speedo... but it never tipped over the crash was almost a year ago just never got it all my parts fixed...it ran perfectly fine last night when i unhooked it all
#9
Re: 07 zx6r wont start need help
ok so the plug near the speedo had a arrow that pointed and said up it was hanging to the side.. put it up and started rite up now just gun have to zip tie it that direction or is it better to bypass it
#10
Re: 07 zx6r wont start need help
Take it apart and take out the wheel inside, then reassemble, DO NOT ZIP TIE IN PLACE you will be asking for trouble
Thread
Thread Starter
Forum
Replies
Last Post