i striped screw so i drilled hole as deep as possible without breaking screw wall. Insert Screw Extractor and then sucker broke in half stuck in there. what should i do to get that SCREW OUT... i got the pic but dont know how to upload

 

I don't know what you can do now that you have gotten to this bad place but to prevent it in the future you should buy one of these...

http://www.sears.com/sr/javasr/produ...cemldffidflk.0

 

how did u break the back out? try gettin a good drill and puttin it on the end of the backout and see if it can catch. i had to use a hammer drill to get mine out one time, pain in the ***

 

i got the the pic tried to upload dont know how. it said please enter the URL of your image HTPP:// ????

 

go to your local parts place and get a set of left handed drill bits, heres what you do, drill a very small hole in the extractor with a normal bit , then take a size bigger than that on ,only left handed and the insert will come right on out