this **** is comin out of nowhere

i don't run gagues so idk exactly at wat rpm the noise comes on but id have to guess around 6 or 7k.

when i rev it up to that point....it just goes "bzzzzt". again, "bzzzt"

sounds like a loose washer rattling.

im not 100% about this but it seems to be coming from the back/center....around where the subframe bolts on to the frame.

..it started yesterday.

has anyone else had this problem be4? any ideas?

 

tighten your cage, 905 rattle really loud when they are barely loose

 

genius bro!

...tho i havn't ridden the bike yet, it doesn't rattle anymore when i rev it

turns out that the 14" bolt was loose

took me about 2 hours just to titen that long *** bolt...here is y:

had to loosen the front and lower mount on the right side to titen the rear mount from the other side. the front mount got stuck so i had to take the whole right side off, i started loosen the rear mount(from the other side)...i the mother ****** SNAPPED! not the threaded side, but the head of the bolt. MOTHER ******!

turns out its like a rod and a bolt, since it didn't snap at the edge of the head(snapped in the middle), i was able to screw the rod back into it...and put my cage back on!!!!:YEAH

so once again, 905 is a
PIECE OF ****!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!

 

I had the same problem, then read that.

Just went outside and checked my FI cage and 2 f$&%(ing bolts were GONE.

Thanks