I have know idea how to remove the 2 ignition bolts for the 03/04. There not Hex or allens, it looks like they need to be drilled out

 

ya you need to drill the head off pull ignition out and then use a set of vise grips and unscruw the rest of the stud

 

and we know how you got your 636

 

I started to drill the bottom of heads, but the dam drill bit broke

 

git a nother one

 

can you use a punch and hammer to back the bolts out?

 

Drill it out is the only way?

 

walmart sells drill bits....

 

yeah, those are the ones that broke...... HAHAHAA

 

Before ya mangled the bolt heads, they were star bit heads that ya coulda bought at sears or autozone.

Now ya have to drill em out.

 

some have the security bolts with the tab in the middle ,they are a little diff then just a regular torq bit

 

My f4i has those, whats the proper way to take them off?

 

go buy security torq bits ....snap-on has them

 

Jesus, I've used my normal star bits like 2 times. You'd figure their lack of popularity would be security enough.

 

THEY WERE NOT TORX OR STAR

 

I think honda uses bols that have round ends. best way to take that out is to take torx that is just little too big, hammer it in to the round bolt end, and turn it open. no drilling needed. If you find the correct torx size it's easy.

the bolt is not torx, but torx key can be hammered in to it.

 

only way is to drill, yamaha does the same thing to..

 

correct Yamaha and Kawi use a special bolt where the head shears off when torqued down enough, the only way to remove them is to drill them out...

Use a small bit to drill a pilot hole, then use a bigger bit ....And use lots of oil

 

i used some wax.

 

Wow you all are making this way to hard. Take a dremel tool with a cutting wheel on it. Grind down into to top of the bolt making a slot in it. "make sure it's kinda deep" Use a flat head screwdriver and remove bolt. Little trick used to remove tps sensors on the throttle body of honda cars. It will work trust me.