I need some instructions for 905 cage that goes to 04/05 gsxr 600/750.

Bought one and I didn't get the instructions and I wanna make sure I got all the parts.

Anyone got one they can scan and post up or email to me??

mofat01@yahoo.com

 

just call the guy a 905 and get them to e-mail you one...

 

I got a better chance of winning the lottery than getting ahold of them.

 

dude, it just bolts on... takes bout 30min, and you should be able to tell if your missin bolts

 

No **** it just bolts on.

How can I tell if im missin bolts when I dont know how many i should have?

Hence the need to look at the instructions.

 

(mxd install) how i did mine with out directions. on a 929rr

should have 2 bolts/washer for for where it bolts to the motor. 1 long bolt/washer with a nut/washer for boltin to the swing arm, and 2 spacers. then one bolt/washer that bolts to the bar that runs under the front of the bike.. thats bout it man.. it will prob have a few extra washer just so if you lose one you will have an extra. but other than that its pretty easy to install.

 

that's how it was with my honduh. you might have to cut holes in the fairing but I'm not sure. removal can be done with a saw or torch.

 

its madd easy, just do it up dude.

 

Since no one seems to have instructoins maybe someone can answer this. I already tried contacting 905, no answer, no returned emails, surprise surprise.

I didn't buy this cage from 905 either.



You know the long rod (sounds bad) that goes all the way through the frame behind the motor, does 905 give you a new long rod or do you use the stock one?

 

you should need a new one. it comes with the cage.

 

That would be the rear motor mount, yes you will need a new one to bolt the cage to.

 

thank you, thank you very much

 

all the cage instructions are all most the same...

 

3 weeks later Aaron comes through with some instructions.

You use the stock rear motor mount bolt with 905.

Thanks, got what I needed