Anyone know how to wire up an F4i to run if you dont have the tip over sensor?

 

it has been discussed before somewhere... take the wiring harness on the clutch side and locate the red and green wires...connect them together

I think there are 2 green wires, you want the one with no stripes

if you still have the tip over sensor its easy to tell, just go by the wire colors on there, they are the same all the way to the brainbox

 

thanks Thomas

 

did that do it?

 

or I also heard you can just inject silicone into it. But on mine I connected the two outer wires(one is green & the other is red w/white stripe) together and then clipped the middle wire(white). Has worked perfect except when the wires come loose, so make sure you connect them good maybe even solder them together.
Later

 

Disregard my previous post I just now read that you dont have a tip over sensor

 

Do all F4i's have tip over sensors? Or only some years between 2001-2005 ?

 

alllllllll

 

I wired it up just like Thomas said and it fired right up. I just shortened my erion pipe. It sound great. Its actually more quite, but more of a deep sound. Thanks all.