I have mine set up at 0 degrees. I know there the same cause I shoved a pipe thru both to make sure there aligned. now i want to turn them in but was wondering if any one knew of any tricks on makeing sure both of them are turned in the same.

 

measure from the split in the clip-on (by the bolt) with a steel tape or tailors tape measure and put a mark where you want to be on the clip-on. and on the tripple measure out from the center of the tripple nut each way the same. once u have marked both the tripple and the clip-on just line up the marks and your set. BTW keep the marks there so after you dump it you can tell if they have moved.