just got a sickinnovations round bar and it looks sick :YEAH...came with no instructions tho.

basically what i have to do is drill 4 hours in the subframe right?

and ifso, how am i supposed to know WHERE to drill?

btw, i'm not gonna use it for scraping...or at least not yet....its just gonna be there there for insurance.

 

the flat part goes right up against the back of the subframe. Mark the 4 holes and drill. You might have to grind down the welds on the side of the subframe so the bar fits

 

I had to grind down my welds. Great Bar :YEAH

 

haha i grew up in oldbridge, watcha know about route 9, route 35, motherfukin RAZMATAZ with the dancing robots, do they still have the movie theatre right next door? motherfukin dunkin donuts, white castle,

 

i see....taking the rear cowl off later when the suns out...we'll see.

 

insurance? might want to look over your policy again

 

I Also Had To Grind Down The Welds On My Subframe The Round Bar Is Sic 1 Mounth Of Scrapin And Its Almost Time For A New One Its Gettin Thin Back There

 

i scrape them till you just have 2 post sticking out