for some reason I can not get my clutch to engage. When the motor is running I pull in the clutch and the bike still wants to go, and when the motor is not running I can pull in the clutch but the bike will not roll freely. It becomes hard to move with the clutch pulled in. Has anyone had this problem.

 

adjust the clutch cable at the engine

 

or it is hydrolic rebleed the line that will fix it, that is what happened to my bike just make sure you bleed it right

 

where is the hydrolic rebleed located at. Is it something internal. I tried adjusting the cable but had no luck.

 

uh 636 is cable operated, adjust the cable dipshit, or take it to someone who knows how to turn a wrench

 

how much pull do you have? most people that come into the shop have 1/4 pull on there lever because the refuse to adjust the cable, or you could have had your cable too tight now your clutch is shot because it was dragging so bad. same with the throttle they have a 1/2 of free play. everything stretchs. your owners manual may have adjustment advice.
now that i think about it it could be a buch of stuff......didn't happen to put car oil in your motor because ya know "it's the same thing, oil is oil right"?(sarcasm)