i just made these last week for a freind and i have one just like it on my shifter side that i made about two years ago ,and cutting the pegs down a little is a must....

p.s i used an old drill press and a cross vice with hand cranks ....what a bitch ,wish i had a cnc mill ....my whole bike would be billet..lol

 

I have stock rear sets with solid pegs. Pegs are cut down 1.75 inches.
OMR buy a manual mill and make me a set.

 

i really want one but i wouldn't really use it that often and if i did i would then want one with auto feed then i would need dro guages and then i would want to make it cnc with a laptop and servoes and aaaarrrrrrrggggg you see my point.....lol

 

you guys breaking stock pegs? I mean just by dropping the bikes right?

I get worried doing fast ralph louies on the stock pegs.... i dunno...

 

hhmm omr subcage would cure that fear.....