where do i...
#10
Re: where do i...
I thought you had to sell that 230.
Do you mean pegs on your rear axle? If that's the case, just get some thick BMX pegs, drill out the hole (if needed) and mount them.
Do you mean pegs on your rear axle? If that's the case, just get some thick BMX pegs, drill out the hole (if needed) and mount them.
#13
Re: where do i...
thats not a kit its a bike avalible in i think italy?
http://www.hmmoto.it/ita/scheda.asp?idFam=15&idProd=50
http://www.hmmoto.it/ita/scheda.asp?idFam=15&idProd=50
#16
Re: where do i...
Ok as for wheel conversion go to this site
http://www.procycle.us/bikepages/crf150230.htm
scroll down and you will see the crf 230 rims. than look further for the tires! it will look sick
now as for rear set pegs Ryan from ESD-MFG hooked me up with mines u can try and PM him and hell help you out i believe his name on here is MOORPORT .well heres the pic of my KTm 450 smr with a custom subframe with cut short exhaust can and short 12 bar so its more like a 3:00 bar
http://www.procycle.us/bikepages/crf150230.htm
scroll down and you will see the crf 230 rims. than look further for the tires! it will look sick
now as for rear set pegs Ryan from ESD-MFG hooked me up with mines u can try and PM him and hell help you out i believe his name on here is MOORPORT .well heres the pic of my KTm 450 smr with a custom subframe with cut short exhaust can and short 12 bar so its more like a 3:00 bar
Thread
Thread Starter
Forum
Replies
Last Post
RBrumwell
General Sportbike Discussion
5
04-25-2008 04:33 PM