hmmm.. i usually get about 3 shots and its gone within well under 2 hours

 

me too ... last time, when i got my crown i got 4 novacaine and 4 lidocaine shots ... i was drooling until i went to bed

 

ive spoken to 3 welders today concerning my steering knuckle. Im asking them to cut off the tab, and weldd on a new one that i can drill and tap later. When i tell them its for my brakes, all 3 said "Should work, but i dont want to touch it"

 

so today after work im gonna go to my old apt and pick up my oxy acetylene tanks. The white hot flame will put the beats on anything. The hammas, kid.

 

Why not just find somebody with a drill press and have them drill it out?

 

I have a bad *** drill press. I also have a pile of broken drill bits.

 

Then find somebody with better drill bits. Drill it out bigger and helicoil the mother ******.

 

man i gotta poo

 

Mike good luck with your project.....I'm out

 

Just talked to a local machine shop. The guy said dont even bother trying to drill it without a diamond bit and a lot of time. He referred me to a place to buy diamond bits, thats actually pretty close to my house.

 

Nice "in focus" picture of the pavement. The knuckle, not so much.

 

shut it!!

 

http://www.rsprecision.com/edm-primer.html

check out "tap buster" at the bottom. this place is by my work

 

You made it sound like you had a root canal without.

 

We have an EDM machine at our plant. It is also how the vast majority of our tools are made/modified.

 

The lingo is "burn in". Such as if we wanted to add some stiffening ribs to a part: "We can just burn in a rib or two and it should be good"

 

You need to work on your reading comprehension.

 

Nothing pisses me off more than when coworkers, especially those you are suppose to be friends with, throw you under the bus.

 

Almost got creamed on the way to work today, had to do some emergency off roading.
I was getting off the parkway (which is no trucks allowed) and the ramps are real tight curves, marked at 15 mph, 30 is the best i can do it without rolling lol. So anyway, coming the opposite direction is a kenworth with a lowboy full of concrete barriers. Although his tractor was completely in his lane, a trailer that long was completely into my lane while going around the tight curve. I jumped the curb, and drove through some bushes and escaped with nothing more than a branch stuck in one of my skidplates.
If i were in the neon, the car would be completely fucked right now, a lot more than it already is.

 

If you did your job when you were supposed to, there would be no bus.