im working on getting this

https://www.stuntlife.com/forums/462...aki-636-a.html

 

That's what I figured.

 

Nice. I'm almost positive Scoot has it. If he doesn't I can get it from Farmer. I know for sure that he has it. Everyone is in Indy now so give Scoot a ring because he wont see this **** for days.

 

Ended up buying the blue hull. The search for an engine begins. Hopefully I can find a nice dual carb 650.

 

I wouldn't get hung up on the dual carb. The best setup is a single 44mm Mikuni.

 

I'll run whatever I can find cheap. LOL

 

if the intake ports are relatively close together id rather run one bigger carb than 2 smaller ones much easier to tune right, no syncing issues or any of that bs.

 

http://peopleofwalmart.com/

 

What is the best way to get oil and water out of a hull? Plastic cup them rags when you get most of it out? Then laquer thinner to get the residue off?

 

Zuki, you can just take the metal bumper trim off if you plan on turfing that ****, right?

 

 

xdl was sick ... they got **** right now, run so professionally

 

I'm back ... and I see this ...

 

niner looks like we are going to the dunes 3rd weekend in september if you are interested ... i should look for a dirtbike to grab

 

I'm in. Just need to buy a flag and have the paddle put on.

 

If this stays low I am going to pick it up:
http://cgi.ebay.com/ebaymotors/ws/eB...K%3AMEWAX%3AIT

 

Flippy Floppies!!!

 

you can run in soft sand without a paddle. run like 6 psi front and rear

 

The bumpers are plastic. Yes, you take that off to do the turf. It is held on by bolts. You take the acorn nuts off under the bond line. There should be 4 pieces, front, back, and each side.

Pic of them off.



Pic of them turfed.

 

That motor went fairly cheap. I don't think it was you who got it though.