My New/Old Project...
#1
My New/Old Project...
Well I bought this boat awhile back was gonna drop a new motor in and paint it but ended up moving into a condo and had to store the thing... well, finally got a place to work on it.. soooooooo I started tearing it down since the blazer is now in paint and outta my hands... after picking up a new short block ... 455 Olds... 390hp... I tore the old motor down.. sent the heads out to be gone thru and rebuilt..
Then started updating the body... most of the cuts are made.. and next week im gonna start glassing it back together.. already got new wood cut to replace the side rails..
Whaaaaaaaaaaaatcha think?
Then started updating the body... most of the cuts are made.. and next week im gonna start glassing it back together.. already got new wood cut to replace the side rails..
Whaaaaaaaaaaaatcha think?
#2
Re: My New/Old Project...
1. you have allloooottt of work ahead of you..
2. your Blazer will pull that perfectly...
3. Have fun with that...
4. Now I want a boat..
5. with less work to be done...
2. your Blazer will pull that perfectly...
3. Have fun with that...
4. Now I want a boat..
5. with less work to be done...
#3
Re: My New/Old Project...
300 into the boat and trailer...
300 into the short block..
250 to rebuid the heads..
160 in fiberglass...
and deff some beer money... hahaha.. its not all that bad.. trying to build it for around 2k...
#6
also known as OMR
Join Date: Jul 2006
Location: OMR INDUSTRIES in west palm beach florida
Posts: 79,288
#9
#12
#14
Re: My New/Old Project...
Got the new motor tore down... it was rebuilt 10 years ago and has just been sitting in this guys garage..
Minimal rust... small bit of surface rust on 2 of the cylinder walls.. gonna pull the oil plugs and cam bearings out later and find a place to hot tank it.. and the crankshaft on monday... then hone the cylinders.. pick up some new lifters and rods n start reassembling...
Minimal rust... small bit of surface rust on 2 of the cylinder walls.. gonna pull the oil plugs and cam bearings out later and find a place to hot tank it.. and the crankshaft on monday... then hone the cylinders.. pick up some new lifters and rods n start reassembling...
#16
Re: My New/Old Project...
No huge updates... lil progress here n there.. decided to cut the entire dash out.. and change the whole thing... trying to get the masonite set up how I want it so I can make a mold of the whole thing n get this thing moving fwd.. New interior layouts lookin pretty rad.. ill have pics when the mold is ready..
Timing set.. pushrods.. and new lifters came last week.. along with the 4" red n green led's for the bow..
Hoping to hone the cylinders and finish cleaning up the crank by the weekend and getting the lower end put back together...
Timing set.. pushrods.. and new lifters came last week.. along with the 4" red n green led's for the bow..
Hoping to hone the cylinders and finish cleaning up the crank by the weekend and getting the lower end put back together...
#18