Omr subcages !!!!!!!!!!
SEAT SPREADER COMBOS
Joined: Dec 2007
Posts: 3,001
From: perth w.a australia
Re: Omr subcages !!!!!!!!!!
YOU JUST MM not 3/8s of a 15th of an half an inch blar blar
moving over to the dark side omr?
I Have Too Much Free Time
Joined: Oct 2002
Posts: 16,023
From: Bangor, ME
Group Moderator
Joined: Sep 2004
Posts: 22,023
From: PA
Thread Starter
also known as OMR
Joined: Jul 2006
Posts: 79,288
From: OMR INDUSTRIES in west palm beach florida
Re: Omr subcages !!!!!!!!!!
an't weld and my guy lives a lil far to haul my engine down to him while i have it apart... so I figured out a way to do it the ghetto way.
Grind out the rivet that holds the swivel/cable connector on the end of the stock arm and drill one more hole about half way down the arm.
Get a piece of flat steel and cut it to size... I did about 5/8 - 3/4 extra length...
Mark and drill out the two matching holes to bolt up to the arm... then a 3rd hole on the end for the cable connector.
I used 6mm grade 12.9 bolts and made the holes just a tad small so the bolts actually screwed them selves into the arm... the nut on the bottom is just for safe measure.
†★ King of brake lines ★†
Joined: Jun 2008
Posts: 15,971
From: ™ ♥ ♥ ♣ ♠
Registered User
Joined: Jul 2005
Posts: 8,290
Thread Starter
also known as OMR
Joined: Jul 2006
Posts: 79,288
From: OMR INDUSTRIES in west palm beach florida
Registered User
Joined: Feb 2006
Posts: 23,660
From: down souf
Re: Omr subcages !!!!!!!!!!
no one in jersey has done this. i'm breaking new ground. mike is the closest that has done this.
i did, i read every post related to it too...i just didn't get enough detail and i still don't really get it. its a few pictures, and says "cut metal, add bolts and voila".
i did, i read every post related to it too...i just didn't get enough detail and i still don't really get it. its a few pictures, and says "cut metal, add bolts and voila".
i need to see this thread cuz the one i saw had like 3 pics and that was all that was needed. didnt even need an explanation much.
Thread Starter
also known as OMR
Joined: Jul 2006
Posts: 79,288
From: OMR INDUSTRIES in west palm beach florida
Thread Starter
also known as OMR
Joined: Jul 2006
Posts: 79,288
From: OMR INDUSTRIES in west palm beach florida
SEAT SPREADER COMBOS
Joined: Dec 2007
Posts: 3,001
From: perth w.a australia
bp chaser
Joined: Oct 2002
Posts: 85,653
From: LI, NY and I drive in Australia
Re: Omr subcages !!!!!!!!!!
what i do is take the whole cover off, with the clutch arm sticking out the top of it. If you take if off, you can make it as long as you want for that same reason
I Have Too Much Free Time
Joined: Oct 2002
Posts: 16,023
From: Bangor, ME
Thread Starter
also known as OMR
Joined: Jul 2006
Posts: 79,288
From: OMR INDUSTRIES in west palm beach florida
