Jefe Stunts

Hey guys ive been on this forum for days still without luck. I have an 02 f4i with 954 triple gsxr 750 forks and a gsxr 1000 rim (i was told by the scrap yard the rims are the same as 750) my problem is that when i put it all together both calipers wont bolt in i get one on and the other side is a hair off.. When i take out the calipers the wheel shifts almost an inch side to side. I know this build has be done and i was told it was a direct bolt on thats why i started it but now im in too deep and just want to get it finished. If worse comes to worse i can get the gsxr triple but i don't know what bearings i need to replace on the top triple. If anyone has any insight please letme know asap

Towlieee

Are you sure that your wheel spacers are correct?

What exactly made you deside on a gsxr swap for a f4i? I'm not saying it can't be done, but that isn't something that is common at all...

This forum is pretty much dead, even if it wasn't dead, specific advice like this is few and far between. You are better off going to a regular honda/f4i motorcycle forum, or just looking up specs of the 954 triple vs the 750 triple on their respective websites...

I've personally never heard of gsxr forks on a f4i. I know anything can be done, its just the question of what parts are needed, if anyhting needs to be fabricated, machines, pressed in etc

Jefe Stunts

the axle is the spacers but ive tried left to right right to left flip the wheel. im lost ive been reading that if i used the gsxr triple all i would need is this bearing
https://www.bearingscanada.com/6906-...IaAm-xEALw_wcB
but can anyone confirm.
i knew this site was dead but i figured id try anyways..