i got a 01 f4i ,so my turn signals i ordered have 2 wires coming from it 1 ground and 1 other wire that is supposed to be hooked up to the Turn signal wires

But on my f4i the plug for the stock signals on the wire harness have 2 wires into one plug what do i do? put both wires together and wire them to the after market signals?

 

just connect power to power and ground to ground. whats hard about this

 

just cut the old one off and use those 2 wires... connect them to the new blinker

 

whats hard is that theres 3 wires on the oem wiring

2 that is orange into a orange clip

and one that is in a white clip

the after market signals have 2 wires a power and a ground

WHICH ONE IS POWER? i know the white is ground but which of the 2 orange ones is power?

i dont have the signal switches right now so its a bit hard to test this i jsut wanna hook everything up and make it ready for when i get the signal switches

 

the 2 wires in the orange clip?

 

hook a test light up and see which one blinks the light

 

turn the bike on and turn the blinkers on and use a test light, but the white wire is ground, other two are the parking light and turn single, hook the two orange too power

 

kk thanks


thanks

thing is i dont have the signal switches so i gotta find which wires are the signals on the clip for the switches and close that circut

 

sorry couldnt understand u the first time, u didnt say there was 3 wires

 

no problem man its all good