that's the setup i don't use.

 

i know someone who can build u a bracket reasonably.

 

It is a radial mount but i have seen it done and looks like a good hb setup if you can fab up a bracket to mount it.And did you let the pads set in the rotor??They wont work good until you do

 

Anyone want to ride tonight???

 

im down to ride....whats the destination

 

im going to industrials soon out by me just throwin that out there

 

oo and I used 600 frip sandpaper on the rotor and it stops a shitload better now lol it was really waved from caked on crap

 

but I'm still gonna make a single caliper quad piston setup then I'll be happy

 

Question guys before i spend unnecessary $...

My front brakes are weird as ****...long story short i gotta pumpumpump when im tryna come to a stop....i bled and bled and bled and still doesnt hold pressure...changed the regular lines to stainless lines aswell new pads...still stops the same.....i dont know if its the master cylinder possibly..or maybe the calipers..i have no clue..a local shop near freeport checked it out and they dont kno either, their guessing master but GUESSING..i dont wanna buy one and it dont be that...

any help guys??

 

if you pump it up to pressure, then keep it squeezed tight, will it maintain pressure or will it lose it in a few seconds to a minute?

 

maybe Bent rotors, or it needs a master rebuild kit you don,t need to buy a hole master fix the one you have

 

seconds...basically once the tire moves pressure gone but pumppump it comes back barely...changed 1 rotor RS...put stainless lines changed fluid bled brakes at a shop and nothing..

 

one rotor was bent and i changed that one..the other one is smoooooooth but idk wtf..how much is one of those kits......should i buy one possibly..cause EVEN WHEN I BLEED THE BRAKES I GET NO BUBBLES FROM THE MASTER to show its taken fluid but it is taken fluid.

 

Sounds like a bent rotor still.

 

+2 to bent rotor

disconnect 1 caliper and zip tie it up to something to find out which one

 

werd ima try that tomorrow morning.....................hopefullllllly that works man

 

If your getting no bubbles from the master when you pump it there is something blocking one of the two small holes=may need rebulid kit is cheap maybe $20-$30.But CHECK THE ROTORS AGAIN!!

 

aite thanx kid...matter fact ima do that now since i got light in my garage....see what happens..can i order that kit from like a local shop?

 

bump.

 

^
thanx guys its the other rotor...i took the caliper off like you guys said and **** the damn thing stops lol but now my unk tryna charge me 100bucks for the other rotor....*******..only cause its a customer bike and storage is basically getting his bike takin apart since he hasnt paid in almost a yr lol