booya

yesterday i cut my muffler with a grinder i cut it at the weld on the cap then down by the h in honda. im trying to figure out what to do with the pipe on the inside that leads out the end of the muffler. should i just cut it flush with the other cuts and weld the muffler back together or try and bend that pipe so it exits the end like it did before i cut it.

StrictlyStunt

Are you talking about the baffle? Your asking if you should cut the baffle flush with the rest of it?

shoulda cut the mid pipe instead

Big Float

bend it like it was before so that it still dumps out the end of the pipe, you might have to heat it up

sweet99F4

If you cut off the front of the can you dont have to mess with the baffles at all.