remember the side clutch up attempts lol

 

yeah, you got a point.

i still need OMR to give me a sub-cage

 

i still need chadf to give me mullah

 

Zzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzz someone wake me up when he posts up pics...

neither OMR or scrapeworks does anything for my 06 gix yet.....

now it's my turn..

 

u dont need them to do anything..just go spend a few dollars on some diamond plate and rivet that crap to the rear section of subframe...when u bolt up a 12 bar or round bar its stable as hell..im 240lbs and i scrape hard...my rear section was cracked in 2 pieces since i owned it (bought it wrecked) and it still hold ing fine now that i reinforced it.( u could weld it instead if riveting but im on a budge)...subcage helps though..i rock powers cuz he local, but im sure OMG makes one too to make it sturdier if u like his products...just my 2 cents

 

i don't have one for the 06 gsxr but im trying to get a couple people to let me borrow theres so i can make a jig but they are not stunters and there bikes are minty so they are hesitent to let me wrench on it.....lol

i only use the bike for measurments and a test fit so it wouldnt hurt any thing but you know how people are with there minty bike.....

 

mmkay, I've actually seen these pics before. I think you posted them up in a gixxer thread or somin? Scrapeworks would be pimp, but who has money like that?? I plan on doing sort of the same thing as you did from the day that I bought mine off the showroom floor... That and weld a piece of 1" x 1/4" alum. bar stock up and down behind the frame tabs connecting them together and beefing up where the subframe meets the frame...

And Yea..I'd like an OMR sub-cage a whole lot. I been buggin him about it for almost a year now it seems. lol
Sick Innovations is my second choice, but they just now came out with one I guess plus they never return any email inquiries, and I am willing to be patient with OMR for a while longer... I really like his design much better.

SOMEBODY GIVE ROGER THEIR BIKE PLEASE!! 06-07 600-750 gixxer!!

Now, show me a picture of your tilt sensor Kah... I ben sooo lazy about doing that project!! Only rode it twice for a total of about 40 min each time with lot gearing.... just installed it finally about 2 weeks ago!! LOL Plus I'm too lazy to search around trying to locate it, so if you know, I'd appreciate some help with findin it please. everyone says under the seat, but where and what does it look like??

 

Dont know if this helps but I saw some pics for you.

https://www.stuntlife.com/forums/444...er-sensor.html

 

the tip over sensor is just dangling in my subframe...its a little black box..i mean little, that has 2 or 3 wires to it....and a rubber band type thing around it....when u pull it off and shake it u should here the penjulum thingy rattling around...there u have it..ur tip over sensor...take it aprt....be careful to remeber how u took it apart and how to put it back together.....set it on the table rite side up like its mounted on ur subfrmae...silocone the swingy thing in place, smash it all back together and wala...uve dissabled ur sensor