pic of hand brake , clutch levers setup
#41
Re: pic of hand brake , clutch levers setup
Here you go... i found one....
http://www.spieglerusa.com/cfm/mc_ca.cfm
"The levers, plates and cylinder of the RADIAL 195 are forged parts, and naturally as robust as you would expect from MAGURA. The well-conceived lever kinematics provide the RADIAL 195 with a very long service life."
http://www.spieglerusa.com/cfm/mc_ca.cfm
"The levers, plates and cylinder of the RADIAL 195 are forged parts, and naturally as robust as you would expect from MAGURA. The well-conceived lever kinematics provide the RADIAL 195 with a very long service life."
naaa it looks good im shure it works good too , i just went with the full throttle set up , no complaints , does the job
#44
#50
Re: pic of hand brake , clutch levers setup
This cable routing any good? Still rebuilding, so haven't tested it out yet.
And I see most people have the brake and clutch flip-flopped, but this seems to line up ok... where my index finger is on the edge of the clutch, and my middle finger is near the ball on the Brembo. Any thoughts?
And I see most people have the brake and clutch flip-flopped, but this seems to line up ok... where my index finger is on the edge of the clutch, and my middle finger is near the ball on the Brembo. Any thoughts?
Last edited by pixel 6; 12-24-2007 at 07:24 AM.
#53
#54
Re: pic of hand brake , clutch levers setup
#55
#56
Re: pic of hand brake , clutch levers setup
Here is my hand brake set up.This brake is the touchiest brake i think .It is a brembo from a ducati with a stock clutch lever and the matching front perch brake as well. I am going to get the crg roll a click levers for them soon..Everyone that i let ride my bike is amazed on how well the stopping power is.......but dont like my clutch lol ....
#57
Re: pic of hand brake , clutch levers setup
and the MSR has three psitions for the cable instead of 2 like the moose, which gives you another spot to make it even easier to pull. shorty msr raptor is the ****